Slimelite BBS

Walkman

Back to AMIGA_VIDEO

From Ed Suda · 1996-04-02 03:40 · #76607 in AMIGA_VIDEO

 On 03-29-96 Cory Mason wrote to All... 
 
 CM> I need to convert my walkman from 2 AA bateries to 1 9 volt battery. 
 CM>  
 CM> I've done everything except put in the resister. I am using this 
 CM> equation: 
 CM>  
 CM> R = V 
 CM>    ---      R being the resistance that I need to put in to lower 
 CM>     I       9volts to 3.0volts I don't know what to do from here. 
 CM>  
 CM> Is this write? 
 CM>  
 CM> R = 9V - 3.0V 
 CM>     ---------     How would I find "I" I know there is a way, I just 
 CM> can't 
 CM>         I         recall how. 
 
There is indeed a way: measure it! 
 
The problem is that the current will not be constant, due to the 
characteristics of the device.  When the motor is running, the 
unit will draw more current than when the motor is not running; 
therefore the potential difference across your resistor will 
vary. 
 
You will need some type of voltage regulator circuit.  A simple, 
almost foolproof one involves the use of the LM317, an adjustable 
three-terminal voltage regulator: 
 
      Front view       LM317T pinout 
     ____________ 
    |            |        1 - Adj 
    |     __     | 
    |    |__|    |        2 - V out 
    |            | 
    |------------|        3 - V in 
    |            | 
    |   LM317T   | 
    |            |       The LM317T should be available at almost 
    |1    2    3 |       any electronic supply store (even Radio 
    |____________|       Shack!) 
     |    |    | 
     |    |    | 
     |    |    | 
     |    |    | 
     |    |    | 
 
 
Here is a schematic of a simple voltage regulator circuit using 
this IC: 
                    ___________________ 
V(in)(+)-----------| pin 3       pin 2 |-------------- V(out)+ 
                   |      LM317T       |       | 
                   |                   |       | 
                   |      pin 1        |       | 
                   |___________________|       | 
                            |                  | 
                            | Adj              | 
                            |                  | 
                            |--------/\/\/----- 
                            /         R 
                            \  R       1 
                            /   2 
                            | 
                            | 
                            | 
Common (-) ---------------------------------------------- (-) 
 
Output voltage is given by:  V(out) = 1.25V (1 + R2/R1) 
 
Assuming R1=1000 ohm, you would need a 1400 ohm resistance for R2 
(not a standard value).  You may want to experiment with these 
values. 
 
Measure the output (BEFORE connecting the walkman) with a 
voltmeter, to make sure it works as advertised. <g> 
 
To use the circuit, just connect V(out) to the positive battery 
connector in your walkman, and V(in) to the positive 9V battery 
terminal.  Connect "common" to the 9V negative battery terminal 
AND to the negative battery connection in the walkman (be sure 
not to allow the metal tab on the LM317 to come in contact with 
the battery or connections). 
 
You should note that your battery life will probably be measured 
in minutes.  9V transistor batteries (assuming you're talking 
about the small rectangular MN1604 type), though they deliver 
their charge at a higher voltage than 1.5 volt "AA" batteries, 
don't store MUCH charge.  The battery life might be extended 
slightly by using a "switching" type regulator, but it hardly 
seems worthwhile... 
 
... OFFLINE 1.39 * A mime is a terrible thing, a waste. 

--- Maximus/2 3.01
 * Origin: The Eclectic Lab (1:153/831)