Slimelite BBS

Pace power supplies

Back to UK_HST

From Peter Dalton · 1996-04-14 00:11 · #74841 in UK_HST

In reply to Pace power supplies by Phil Burden

In a message to Peter Dalton <13 Apr 96 08:33> Phil Burden wrote:

Hi Phil,

 PB> Maybe you're right,but how many computer supplies bite the
 PB> dust,I've never come across one..and this is my second dead Pace.

I had one PSU fail on a 22 PC network in 7 months...it does happen
though not often. Having said that, I installed over 100 satellite
systems, mostly Amstrad and Pace and over about 5 years I've probably
only repaired 20 of them, so that's not a high per-centage either.

PC power units are much larger than a sat receivers and I suspect
(though don't know for sure) that they are based on transformers rather
than switch-mode, and IMO transformers are far more reliable. The major
difference is certainly cost, with PC PSU's costing probably L20 to
produce and a sat recievers costing a couple of quid!

 >PD> Our Pace wouldn't have blown if we hadn't had the power off and allowed
 >PD> it to cool down. I knew about the problem but didn't really 'engage

 PB> Wouldn't having a surge supressor on the power line help matters?

I don't believe so. The problem seems to be based around various
capacitors 'drying out' and having their values altered. It's o.k. while
they're hot and expanded but once they cool down their values alter
dramatically...then the power is reconnected and excess current flows
through resistors and/or control chip + switching tranny. It's not so
much a mains surge as too high a current so a surge protector wouldn't
help. It's difficult to prove though as the problem may or may not occur
in almost identical circumstances...it seems to be down to luck as much
as anything IMO.

 PB> Having looked at the psu section of my dead 920,it doesn't look a
 PB> simple exercise to replace the components,with them being mounted
 PB> on a single pcb.
 PB> You don't happen to have a cct diagram for the beast,do you?.

erm 920? Do you mean 9200? I have service manuals for the older sets,
Amstrad 400, 500, 510 and Pace 9000, 9200 and 800/900. As I stopped
installing a couple of years ago I haven't bought the newer manuals or
kept fully up to date with the current model numbers, sorry. I still get
the Pace Service Matters with up to date info though, and I'll probably
get Eurosats Repairs Manual III in the near future for reference.

Changing the components isn't as bad as it looks, I do one at a time and
work steadily through it. The worst problem you will have is that some
circuit tracks are a bit fragile and can be 'lifted' by applying too
much heat. I use a solder-sucker which isn't the best thing to use (but
it's all I have and I can't get on with braid!) and can damage the pads
that the control chip attaches to.

 PB> I noticed that there are two supply ccts in the Pace,does the kit

two supply circuits?

 PB> replace just certain components,or all of them?.

just the ones that cause trouble, about a dozen or so on the 'hot' side
of the transformer. One thing I liked about the kits from Economic
Devices is the list of component numbers *and* values. It's a simple
test with a meter to decide, for instance, which resistor goes where as
it's sometimes impossible to read the colour bands on the old one...

The list includes common faults too.

Regards
Peter

--- PCRR 1.05/b+
 * Origin: Aspects BBS - Manchester UK - +44-61-792-0260 (RA 2:250/107.80)