Slimelite BBS

Feeder

Back to KERRANG

From Andy Ball · 1996-04-05 03:54 · #69122 in KERRANG

Hallo Jonathan !


BT> ...but also I think there is a chance of getting a perfect coil,
  > of the right size, which could actually improve your Tx/Rx.

    I haven't checked the date of this message, but I'm sure it was
early for April 1st !  ;o)


JH> Hmm... What if the cable, when laid round my walls, becomes two
  > or three 1/4 wavelength lengths?!
 
BT> I also remember being told something about there are lengths of
  > cable which you should avoid, I think it was multiples of 9ft
  > (1/4 Wavelength), but not 100% sure on that figure.

    Smacks of much of the coax length mythology that used to float
around the CB community.  I think much of this came from people who
were trying to make SWR readings from the rig end of the feeder, not
a good idea because the reading will depend where the coax is cut
(although the actual SWR won't !  ;o)

    The way I understand it, the length of your feeder isn't going
to make a significant difference to your station's performance.  It's
true that a /very/ long feeder would introduce some losses, but nowhere
near as much as some CBers seem to think - including those unfortunates
that splashed out on RG8/U !

    Much more important would be the location and tuning of your
antenna, although there's probably even more misinformation floating
around regarding this !  I think someone also mentioned coiled cables
heating up, I've seen this happen with mains cables, but I doubt very
much whether this is likely to be a problem with the low powers present
in CB radio feeders, especially as coax is designed to minimise
radiation.


  JH> ... Ok, now for a quick backuÃá&ý#^1sð

< evil grin >;o)

Regards,
  - andy.

--- Hqwk V6.5 [JetMail 0.99beta21]
 * Origin: WALU minus the soft half ! (2:255/80@fidonet.org)