Slimelite BBS

Evans Reply to you

Back to AMIGA_VIDEO

From Gary Depietro · 1996-04-02 12:24 · #76683 in AMIGA_VIDEO

Msg # 11013                      Date: Fri  3-29-96,  3:15 pm  [I]
From: Evan Soule (josephnewman@earthlink.net)

Area: National Science Echo 
>  From: Chris Lawrence                               Read: Yes    Replied: =
>Hi Gary,
>
>Gary Depietro wrote in a message to All:
>
> GD> The following is an explanation of Newman's theory
>
>(not)!
>
> GD> Using 30 gauge copper wire with .1 ohm resistance per foot [each
> GD> turn of wire consisting of 1 ft. of 30 gauge wire], the following
> GD> facts are shown if one uses a battery power source of 1.5 volts
> GD> producing only a maximum of one amp:
>
>At last!  Some figures to get hold of!
>
> GD> 1.5 volts TIMES 1 amp EQUALS 1.5 watts input power going through 1
> GD> turn of 30 gauge wire EQUALS 1 amp turn strength of magnetic field
> GD> produced.
>
>What strange units, "amp turn(s) strength..."!  I much prefer to measure my
>magnetic flux density [MFD] ("strength of magnetic field") in Tesla.
>
>Anyway, this 1 turn (or n turns) of wire of one foot (!) in circumference w=
i
>have a radius of approx 49mm =3D> 0.049m.  Tell Newman to get used to these=
 ne
>fangled units, such as 'metres', etc.
>
>The resistance of 1 turn is 0.1 Ohm.  This 'coil' will draw 1.5 / 0.1 =3D=
 15 A
>of current from the battery BUT the battery will only supply 1A and the inp=
u
>voltage will drop significantly.
>
>This means that the MFD within the coil is (1.26 * 10^-6) / 0.098 =3D 1.29 =
*
>10^-5 Tesla.
>
>Power of coil =3D 22.5 W (theoretically) and 1.5 W (really).
>
> GD> 1.5 volts TIMES .05 amp EQUALS .075 watts input power going through
> GD> 100 turns of 30 gauge wire EQUALS 5 amp turns strength of magnetic
> GD> field produced.
>
>The resistance of 100 turns is 10 Ohms.  Now the coil will draw 1.5 / 10 =
=3D 0
>A and the battery will supply it.
>
>The MFD within the coil is (1.26 * 10^-6 * 100 * 0.15) / 0.098 =3D 1.93 * 1=
0^-
>Tesla.  This is greater than the last one =3D> the magnetic flux, since it
>occupies the same area, has increased.  This is due to the fact that the
>battery could previously only supply 1 A.  If it had been able to supply 15
>as the wire demanded, then the MFD would be the same as this.
>
>Power of coil =3D 225 mW
>
> GD> 1.5 volts TIMES .005 amp EQUALS .0075 watts input power going
> GD> through 1,000 turns of 30 gauge wire EQUALS 5 amp turns strength of
> GD> magnetic field produced.
>
>Resistance of 1000 turns is 100 Ohms.  Current drawn is 15 mA.  MFD within =
c
>is (1.26 * 10^-6 * 1000 * 0.015) / 0.098 =3D 1.93 * 10^-4 Tesla.
>
>Power of coil =3D 22.5 mW
>
> GD> 1.5 volts TIMES .0005 amp EQUALS .00075 watts input power going
> GD> through 10,000 turns of 30 gauge wire EQUALS 5 amp turns strength
> GD> of magnetic field produced.
>
>Resistance of 10000 turns is 1 KOhm.  Current drawn is 1.5 mA.  MFD within =
c
>is (1.26 * 10^-6 * 10000 * 0.0015) / 0.098 =3D 1.93 * 10^-4 Tesla.
>
>Power of coil =3D 2.25 mW
>
> GD> CONCLUSION:  Observe that the current and watts input consistently
> GD> DECREASES as the number of turns of atoms comprising the coil
> GD> INCREASES and yet the strength of the magnetic field produced never
> GD> decreases.
>
>CONCLUSION:  Observe that the current and power requirements of the coil
>decrease as the number of turns increase.  The magnetic flux within the coi=
l
>remains the same in each case.  The number of turns contributing to the MFD
>increases, but, with each turn the resistance increases which reduces the
>current contributing to the MFD.  The result is a balance between the numbe=
r
>turns and the current through them.  Increased turns increases the efficien=
c
>THE EFFICIENCY DOES NOT INCREASE ABOVE 'UNITY', AS THIS IS NOT POSSIBLE.  Y=
O
>DON'T GET OUT MORE THAN YOU PUT IN.  AT BEST YOU BREAK EVEN.
____________________________________
To Chris:
The purpose of this example was NOT to demonstrate "over-unity" which has
NOTHING to do with the example provided.  If you fail to see the point of
this example then, indeed Chris, for you it is pointless.


And, Chris, since you brought the word "over-unity" up in this context, I
have a simple question for you --- and it's one involving "a matter of
semantics" and/or a "paradigmological" question:

Would you consider a typical, conventional, nuclear fission reactor/power
station complex to be "an over-unity" operation?

If yes, please explain or, if no, please explain.
Evan Soule
_____________________________________
>
>I have shown that the "current and watts input" consistently decrease as th=
e
>number of turns of wire on the coil increase, and yet the strength of the
>magnetic field produced never decreases.  Newman fails to demonstrate anyth=
i
>which we haven't already known about for well over 100 years.
>
> GD> Simply put, the SAME strength magnetic field can be produced while
> GD> consistently DECREASING the current and watts input.
>
>....by increasing the number of turns of wire within the coil.  YES!  We al=
l
>knew that!  BUT it has NOTHING to do with copper atoms or copper at all.  T=
h
>number of turns of conductor is quite enough.  In fact, there doesn't even =
n
>to be a conductor - an electron moving around a nucleus is a classic exampl=
e
____________________________________
To Chris:
It has EVERYTHING to do with the COPPER ATOMS.  If you wish to learn how,
read Joseph Newman's book.  If you don't believe it does, and refuse to
read the book....well, you know what they say about leading horses to
water....this technology IS going forward....you can debate it or question
it or ignore it....fortunately for humanity, this technology's going
forward isn't dependent upon whether you accept it (or not)....Gary has
been presenting information about it such that those who wish to examine it
further and build it for themselves can do so.....those who wish to play
Cremonini can also do so..... in the case of a "Cremonini" I could really
care less.  To some (not all) of you: I don't really appreciate your
"two-bit," snide remarks (found throughout your comments) to Gary -- if
this is your best attitude, then you can take your attitude/remarks and
shove them where the sun don't shine. And guess what (to those to whom this
applies)? If you don't like this remark as well you can shove it too.
Evan Soule
____________________________________
>
> GD> The accuracy of the above mathematical results relating to Joseph
> GD> Newman's technology are confirmed by those results being applied
> GD> for ANY reasonable length of time, for instance, one hour.
>
>I have to laugh - Newman is only 176 years behind Oersted in his experiment=
.
____________________________________
To Chris: I have to laugh too, Chris.  Joseph Newman IS about 176 years
behind the incorrect conclusions reached by Oersted in his experiment and
this is why he is correcting such incorrect conclusions.....and you want to
know what's really a laugh?: because of Oersted's incorrect conclusion,
people have been building (convention) motors back-asswards!  You're right
--- this is pretty funny!!! <grin!>
Evan Soule
____________________________________
>
> GD> These facts clearly prove that the magnetic field produced in a
> GD> coil comes from the ATOMS comprising the conductor and NOT from
> GD> the watts or current input as conventional science and the Patent
> GD> Office incorrectly teach.
>
>Oh, get real Gary.  See the light.  Get onto a physics course.  To use your
>words - FIND OUT FOR YOURSELF.
____________________________________
To Chris:  Yes, Chris: get real! --- FIND OUT FOR YOURSELF...words of
Olympian advice which you offer yet do not follow yourself. Take a lesson
in intellectual honesty.
Evan Soule
____________________________________
>
> GD> [Dr. Moragne was an electromagnetic pioneer in the development of
> GD> the first atomic bomb.]
>
>Really?
_____________________________________
To Chris: Really.  --- Evan Soule
_____________________________________
>
>Regards, Chris - in Liverpool, UK
>FidoNet: 2:250/163.7 - Internet: chrisl@wsbbs.sentinel.co.uk

> GD> As some of you may recall, Matherne has done quite a bit of testing
> GD> on Newman's Energy Machine. You will note his address is at the end
> GD> of this post. Anyone want to check him out? gary
>
> GD> Robert Joseph Matherne, Physicist
> GD> 217 Timberlane Road
> GD> Gretna, Louisiana 70056
>
>        I already checked him out, Gary.  I already had
>        this address before you posted the Metairie, LA
>        address for him.  Guess what?  Robert Joseph
>        Matherne has no telephone listing in Gretna, LA.
____________________________________
Reply to Stuckas(SENO):
Guess what? It so happens there is a "technology" called "unlisted
numbers."  I know this may be rather advanced for you Stuckas(SENO), but
such telephone numbers really DO exist.
>
>        I did talk to one Robert Matherne, but he was
>        an old guy on social security disability and
>        assured me he was never a physicist and had never
>        worked for the company who runs Louisiana Power
>        and Light.
>
>        Wanna try again?  Gretna is awfully close to where
>        Evan Soule lives.
>
>... Consistency (laziness) is the last refuge of the unimaginative.
_____________________________________
Dear Stuckas(SENO):
Yes, laziness indeed!  As a matter of fact, Gretna is just across the river
from where I live.  And to anyone else [other than Stuckas(SENO)] if you
wish to contact Robert Matherne, Physicist, write to him at the above
address.  He has an unlisted number because he does not with to receive
telephone calls from the Stuckas(SENO)'s of the world.  Perhaps with a bit
of investment of the time to send him a letter, others who may be
intellectually honest can communicate with him.  If not, so be it.
Evan Soule
_____________________________________





... A feature is a bug with seniority.
--- Proboard/Fastecho/InterMail
 * Origin: The P.I.T.S. BBS = Orange City, Fl = 6 Nodes = 904-774-6577 (1:3618/12)