From Ron Freimuth · 1996-04-03 17:49 · #76622 in AMIGA_VIDEO
PR>|o| >you have an old car you only start every couple of months to keep it
>|o| >from freezing up, like the '67 Alpine I have in the garage, it'd be a
>|o| >good idea to put STP in the oil.
PR>RF|o| It increases the viscosity of engine oil so in cold weather it takes
> |o| longer to get a good oil flow. Probably causing more harm than good.
PR>In such climates people typically have heated dipsticks. Heck on the
>North Slope ordinary hammers became so cold-embrittled that they became
Not many live far from the coast in Alaska. I grew up in Northern
Wisconsin, only a few people did something to heat their engines.
After sitting a - 10F for half a day, the 10W-30 oil on the dipstick
turned to paste. Without STP.
>useless. Obviously local conditions are important. I used to run
>straight 40 weight in that engine, year round. I was in LA, not
I used #30 in the SF Bay area. After the speed limit dropped to 55,
I used 5W-10. It was supposed to be good for temperatures up to 90F.
At 55 my V-8 was only putting out about 10% of its maximum. So, I
figured I didn't need heavy oil. And, would benefit from lower viscous
friction of the light oil.
PR>RF|o| This of this: if a more thixotropic property were desirable for
> |o| engine oil it would be part of the manufacture's specification. If the
PR>It depends on the basic assumptions being made about the service
>conditions of the engine. Recommended oil change intervals always have
>caveats about the service conditions. Nissan recommends 7500 miles for
>my pickup, assuming ideal conditions obviously. In my case this engine
>is not being "used". It's more important to keep SOME lubrication on
>parts between starts, it's in an "attached" garage and weather
>conditions here are not severe.
Hot Start tests are part of standard oil specifications. If any
more additive were required in standard oil it would be compounded in
during manufacture.
Engine wear is highest during warm up. The rate decreases to a low
asymptote once the cylinders are past about 170 F. The reason may be
acid condensation on the cylinder walls. Certainly it is not due to
lack of lubrication after the engine has been running a minute, but is
still cool. The minimization of water jacket volume, block mass, and
the fast idle warmup did a lot to minimize engine wear during warmup.
Especially the fast idle that came into use in the early 1930's.
There are always plenty of Urban Legends going around on auto
engines. I base some of my statements on an engineering book 'The
ICE', 1966.
---
* OLX 2.1 TD * How is your Kurtosis?
--- FidoPCB v1.5 beta-'j'
* Origin: Lunatic Fringe * Richardson,TX * 214-235-5288 * (1:124/2113)