From Peter Dalton · 1996-04-11 21:38 · #74821 in UK_HST
Hi Phil
In a message to Peter Dalton <10 Apr 96 22:13> Phil Burden wrote:
!!!!!!!!!!!!!!!
PB> On Apr 10 15:22 96, Peter Dalton of 2:250/107.80 wrote:
!!!!!!!!!!!!!!!
bluddy 'ell...that was motoring :-)
PB> Why is the Pace so susceptible to this phenomonen?..I've just
not just Pace, it's any of the cheaper sets...erm, Amstrad and Pace are
the main suppliers. Having said that the old Ammy SRD400 gave no power
problems unless you shorted the LNB feed, but that was based on a
transformer with voltage regulators. Personally I can't stand the
switched mode power supplies that they use now, very unreliable IMO.
PB> bought a brand new 960+,it only lasted 20mins before it gave one
'bath-tub diagram!'. :-) If you plot the faults over time on a graph
for any electrical equipment, with time on the horizotal axis and number
of faults on the vertical, you'll see a lot of faults in the first few
hours dropping during the first week to be almost zero. Then changing
the scale you'll see a gradual rise in faults over the next 3 - 5 years
with a sharper rise as the equipment ages. The graph looks like a bath
tub seen from the side.
Mechanical gear would have a similar graph for failures...and I suppose
marriages do too... :-) Anyway, it's a common problem with almost
anything and if it gets past the first few hours/days then you'll
generally have no trouble for a couple of years.
Our Pace wouldn't have blown if we hadn't had the power off and allowed
it to cool down. I knew about the problem but didn't really 'engage
brain' as I could have easily popped the receiver into next door for
half an hour to keep it hot. Such is life.
PB> took out the regulator and a resistor,"quite common with Pace" I
PB> was told..never happens with 'puters <grumble>
well yes, relatively easy to cure by changing a few components, except
mine didn't come back up. I reckon it's the control chip that's faulty
and I may have damaged it with too much heat as I took a couple of
circuit board 'pads' off. Again it's my fault for being so clumsy.
Anyway, I found the hard-copy of the message and called the guy in
Wolverhampton...a new PSU kit should be here tomorrow so I'll try again.
Regards
Peter
--- PCRR 1.05/b+
* Origin: (RA 2:250/107.80)