Slimelite BBS

a cheep cb antenna

Back to C_ECHO

From Bill Rister · 1996-03-30 13:04 · #72702 in C_ECHO

 On 03-29-96 Thad Sowinski wrote to All... 
 
 TS> Well I have a Lady Friend that I have been trying to get into 
 TS> Amateur Radio and she like Cb's.   Well She has a Base and need a 
 TS> cheep antenna.  Her Base is also Mobile.   Can I make a Cheep 
 TS> Antenna for her House.   Linda Just lost here Job and Cannot 
 TS> Spend Money For a Nice antenna.  She has two kids to feed. 
 TS> Wire Antenna or Something Cheep I can fixed here up with. 
 TS> 
 TS>   Is this Possible ??? 
 TS> 
 TS> Thank you and 73's de Thad   KB8YIG 
 
 I see by your call that you have tested and passed your Technician 
 class license Thad.  While we'll surely get repriminded for discussing 
 CB or 11 meter radio on this echo I feel that your question deserves 
 a reply.  As a technician class amateur you should be able to build 
 a simple wire dipole for 10 meters.  What's so hard about doing the 
 same for a slightly different frequency?  Check out some of the 
 reference books available at your public library.  Or pick up one or

 two of the antenna-specific books available at your local bookstore. 
 That's part of the fun of ham radio.. trying and doing.  To get you 
 started, try a horizontal quarter-wave dipole strung along the peak of 
 the roof if possible or mounted anywhere else on the roof if not. 
 I said along the peak because I was thinking of the highest point. 
 The dipole can be constructed of two lengths of wire 102" each. 
 Connect the RG-58 coax shield to one wire and the center conductor 
 to the other.   The impedance will be about 73 ohms and swr will not 
 be flat but the antenna will work.  You could also use low-cost 
 aluminum tubing or rod from your local builder's supply or hardware 
 store to make a quarter-wave ground plane.  Mount the driven element 
 (102") vertically on a short board.  Connect the coax center conductor 
 to that element.  On the bottom of the board connect four rods so they 
 will droop about 45 degrees.  These can be the aluminum rods or tubes 
 OR something like #14 wire.  An insulator at the end of each wire 
 will allow you to string more wire on the other side of the insulator 
 for support.  Connect the coax shield to the four radials and you 
 have a simple ground plane antenna with 50 ohm impedance.  YOU can 
 apply the same principles for your own ham radio. 
 
___ 
 * OFFLINE 1.56 * The best angle for solving a problem is the tryangle. 

--- Maximus/2 3.01
 * Origin: USS Pegasus/2 * Inet: 128.249.250.42 * 713-355-1194 * (1:106/9636)