Slimelite BBS

Re: Promoting Screens

Back to CLUB_AMIGA

From Asha Develder · 1996-04-07 01:45 · #70006 in CLUB_AMIGA

Michael,

 AD>>       What screen ID?  I never fooled around with any of that....

 ML> In FZI, I can't remember if it is in General 1 or General 2, but
 ML> somewhere along the way you get a prompt for the ScreenID, it says if
 ML> you don't know it or if you're running dos 1.3 leave it blank.  I did.

        I must have too, since I don't know anything at ALL about ScreenIDs.

 ML> Well, it's still not fixed, as I said, picking No, just switches the
 ML> screen from the Picasso 800X600 to NTSC Hires 640X400.  And Picking
 ML> Now and selecting either Picasso 640X480 or Picasso 800X600 it uses
 ML> only the top half leaving a blank space underneath.  I can't use the
 ML> whole screen.

        That's truly strange.  Does this happen with any other program? Have you tried promoting any other program to a different resolution than your workbench?  I'm running everything that goes through the Picasso in 640X480.  The only other thing I can think of is monitor (physical) settings.  My Nec 3D has a memory for different modes.  It "remembers" how to center the screen, how high, how wide each mode (Pal, NTSC, etc.) is and re-syncs when I change modes.  Could that be the problem?


                  Asha.DeVelder.SysBabe-*-Moderator.standin
      -*-INT:76703.4322@compuserve.com...Charter Member: Team AMIGA-*-

 * A rabbit can blow its ears off by sneezing.

-*- ASTG 1.9


---
 * Origin: Don't bite my finger; Look where I'm pointing! (1:209/245.5)