Slimelite BBS

Monitors and Other Viewpoints

Back to GRAND_PRIX

From Eddie Moore · 1996-04-12 04:36 · #69640 in GRAND_PRIX

Hello Adrian!

In a message of 31 Mar 96 Adrian C Symonds wrote to me:

 
 ACS>> I heard about that, I could not believe it when I heard.

 EM>> If you think about it, it makes sense.  Generally, the average office

 ACS> Me?, think?, You must be joking. :-))

Remember, *you* said that B-)


 EM>> manager hasn't got a clue when it comes to selecting the optimum
 EM>> location for a monitor, so any guidlines or rules /should/ help them
 EM>> make that

 ACS> Thats true, and they don't have to use them.

No, perhaps not, but if they receive any comlaints from the monitor /users/, they are obliged, under the Health And Safety At Work Act, to take remedial steps.  Any failure to do so can be, and often *is*, referred to the HASW people, who make then sure that those "guidlines" are followed.  It's a similar situation to the Highway Code;  much of what's in there isn't /actually/ law, but can be referred to by the police should they feel that a motoring offence has been committed.


 EM>> decision. Part of my job involves visiting customer's sites and
 EM>> surveying the office/control room, in order to determine the best
 EM>> position for

 ACS> Sounds a good job, nice and easy.

ROTFL!!!

*That* part of my job is easy, or, at least, it might *seem* that way to the casual observer.  Now, let me tell you about some of the other aspects of my "nice, easy" job - how about being stuck for hours on end in the hold of a noisy ship, covered in diesel, trying to figure out exactly /why/ some obscure bit of kit has shaken itself to death?  Or how about the stress-inducing helicopter flights necessary to visit an oil rig in some unearthly corner of the North Sea, with fog and wind so bad that, even with radar, the pilot can't even *find* the rig, and has to head for home before his fuel runs out?

Still fancy my nice, easy, job? ;-)



 EM>> control desks, monitors, lighting, etc.  The sad thing is that the
 EM>> majority of new installations completely ignore my recommendations,
 EM>> and on subsequent visits I end up with earache from unhappy process
 EM>> operators B-(

 ACS> They do it to cut cost's, I bet your recommendations cost money, but
 ACS> what's money if the operator is not happy.

In most cases, they /don't/ cost money, or, at least, no /extra/ outlay - this is especially true where a new control room is being built.  A lot of it comes down to the old "We've *always* done it this way" mentality B-\



 EM>> In the case of the Aydin range, it's definitely down to the
 EM>> electronics.

 ACS> That dull are thay?

Under the wrong circumstances, yes.  Mine's fine, though;  it's sited underneath a shelf, which reduces the amount of light falling on it, and the main light in the computer room is sited above and *behind* the monitor, thus reducing glare.  Remember what I said about part of my job being to make recommendations on monitor siting?  I, at least, follow my own advice - and it works ;-)


 ACS>> Yuk, just like the old CBM ones, my old one for the 64 did the same
 ACS>> thing.

 EM>> Odd, that;  the old C= monitors were based on Philips models, and they
 EM>> were okay in that respect.  In fact, I have one at home which is still
 EM>> giving sterling service, and it's over seven years old now.

 ACS> I think this one was a one of, the ohter thing that annoyed me was
 ACS> that the speaker was not sheilded so it caused a blue fringe in the
 ACS> one corner.

Again, mine was/is okay in that respect, although I do know of other people who have had such problems.  Still, /real/ monitors don't have speakers ;-)



 EM>> I know a few people who have (sorry, *had*) the Opalvision card.  They
 EM>> were most impressed with its performance, but like you, they were not
 EM>> so

 ACS> I used it for a week, brill.

Just two days until I get a Picasso B-)))

Unless, of course, something goes wrong...


 EM>> impressed with the support.  The long-promised add-on modules simply
 EM>> never appeared B-\

 ACS> Nor they never will, I heard they gone bankrupt.

So I believe.  There /was/ talk of another company buying up the manufacturing rights, but nothing concrete has materialised.


 EM>>> Hmm, I don't suppose anyone'll advise me to upgrade to a 4000, will
 EM>>> they?

 ACS>> Upgrade to a 4000, just like I did. :-)

 EM>> Trust you ;-)

 ACS> In fatc, I think the best way is to get a 1200, a towercase with Zorro
 ACS> III slots in and do it that way, you get a 4000/T for half the price.

I probably /would/ go for such an option, if I didn't already have all this reliable kit.



 ACS>> Come to think of it, you proberly better off, sticking a 1200 in a
 ACS>> tower system.

 EM>> I'm probably better off sticking one of my 2000s in a tower system B-)

 ACS> Nay, better of with the 1200.

But I'd have to add an accelerator and throw *lots* of memory in, just to get it to equal the spec of my current set-up.  Then there's the little matter of the HDs, although I suppose I /could/ slot my ZorroII 2091 into the 1200 tower.  Nah, I'll stick with the 2000 for now, and see what develops...

 
regards,
Eddie

... Member:  Team AMIGA
--- Spot 1.3a #709
 * Origin: Amigaholic's Workshop;  off Aspects (2:250/107.109)