Slimelite BBS

Transistor voltage compare

Back to KERRANG

From Daniel Brook · 1996-04-13 19:13 · #69188 in KERRANG

 -=> Quoting Richard Gregory to Michel van der Heijden about Transistor voltage compare <=-

 RG> So what I'm after is a transistor circuit that will compare two
 RG> voltages without the awkward supply voltage problem and the comparing
 RG> close to the (0V) supply rail problem.  The comparer can still use a
 RG> regulated voltage  source (a constant voltage is required by the other
 RG> parts of the circiut). 

 Have you considered using a voltage comparator chip? Look in the Maplins 
catalogue or whatever reference you can for them, e.g. LM393.

 This is a dual voltage comparator with an open collector output. It will run on
a single supply rail 2v to 36v. The output is high (if a pullup resistor is
connected!) if the "+" is bigger than the "-" input, and low if "-" is bigger
than "+". Obvious really :-)

 TTFN,

 |\
 |/an

--- Blue Wave/RA v2.12
 * Origin: From The Crystal Tower : London (0181-4478244) (2:254/220)