From Richard Murray · 1996-04-04 06:50 · #69143 in KERRANG
Quoting Stephen Hill (in BOFFINS)... SH> quality goes down, but if I keep the PSU plugged into the circuit, but SH> turned off at the mains, the whole thing works just as well! Possibly the parallel port... I remember once I powered my Acorn A3000 with just the +5V lug connected. The screen was darker and flickered when accessing the floppy - but it worked. It turns out the PSU was forming a big current loop via the monitor (shielded video cable). It worked (darker) when I plugged the monitor in a friends house on a different phase and my computer here. Using half the town as a current loop... <giggle> SH> from... I suspect the parallel port, but is it safe to draw this power SH> from the port or is it likely to damage it by drawing too much current? Depends on the build. If you have the parallel straight out of the IOC then you should be careful. If it is buffered, make sure it is useful buffering and not some crappy TTL. I have seen some ports blown by those old 20chars/minute [:-)] type printers - so a good manufacter would have put some care into it. Or maybe you use one of those £10 parallel cards. :-) SH> BTW, if it's all ok to run this circuit without the PSU, why did the SH> author say that you need one??? :) Again, my computer worked - but I think the less Acorn know about it, the better they'd feel. :-) ___ /__/ / \ichard. --- 8 out of 10 BSE-infected cows say '!ooooooooM'. * Origin: Worrying Heights [Encina] (2:254/86.1)