From Paul Ellams · 1996-03-25 02:27 · #69057 in KERRANG
-=> Quoting Jason Burns to Paul Ellams <=-
JB> Yep no probs, data on the communications would be great thanks. I
JB> still think it would be possible since when I turn off my MSS200, it
JB> turns of the positioner by its own accord. Hence my reasoning that I
JB> could use that to turn off teh d2mac rx as well.
Your correct, I had another look at my software and I am using the receiver
data to turn the positioner into standby. (sorry about the mistake).
When you turn the receiver off the satellite Number 127 is sent out of
the receiver.
Anyway heres how the data is sent.
Receiver sends start bit + 7 bits for sat number + 1 bit for
polarity.
Data is Pulse Position Modulated (PPM) with a Logic 1
being 86uS from the previous bit, and Logic 0 is 64uS
from the previous bit. Pulses are 2.75uS wide.
Unfortutely a standary 4mhz pic84 is not quick enough to see these pulses
so what I did was feed the pulse into 4017 counter. The pic chip monitored
the second count of this chip. When it saw one it reset the 4017 chip, with
an output connected to the reset pin of the 4017. The pic then counted the
time until it received another bit. And used this time to decide whether it
was on or off.
Hope this helps,
Paul Ellams....
... "Yield to temptation, it may not pass your way again." - L. Long
--- Blue Wave/386 v2.20 [NR]
* Origin: Xstream 44-151-488-0698 V21-V34 [OS2/Max3.00/Md1.02e] (2:250/210)