Slimelite BBS

Re: Fitting CD To A1200 IDE

Back to AMIGA_OS&EM

From Gary Colville · 1996-04-12 05:49 · #67671 in AMIGA_OS&EM

In reply to Re: Fitting CD To A1200 IDE by Peter Hutchison

Oh no! On 03 Apr 96 that loony Peter Hutchison wrote to Grant Powell :

PH> The A1200 IDE interface is designed for hard disks and if you 
PH> did use a IDE CD-ROM drive it WILL slow down the hard disk 
PH> because it is sharing the same cable! 

Rubbish! Adding an Atapi CD-Rom will have no impact on the hard drive
whatsoever. While the HD is transfering data the CD-Rom simply sits
idle and waits for the bus to become available again.

It's worth noting that, as most Scsi drives on the miggy rely on a
squirrel interface, an Atapi drive attached to the internal IDE
port will use *much* less CPU time during transfers.

PH> It would be just as cheap to get either the 4 speed Overdrive from
PH> Silica or the Q-Drive from AmiTech. 

I don't think so. Quad speed IDE drives can be had for about 50 quid,
with six speed devices coming in at about £90.

PH> You could get a SCSI CD-ROM for better results.

Better? In what way? An IDE drive will perform exactly the same
as a Scsi one. In fact, for the same cost you'll be able to get
an Atapi drive that is two or thee times faster than a Scsi job.

 
+------------------+----------------------+-------------+
| Gary Colville    | A1200/030 10Mb 36MHz | Member:     |
| Fido 2:259/68.19 | 1270Mb IDE  4xCD-ROM | Team AMIGA  |
+------------------+----------------------+-------------+

... Sex is better than logic. You can't prove it, but it is.

--- Cyclone FTN 0.75a 
 * Origin: The Old Bugs Home (2:259/68.19)